This product is low in stock. Please call the office.
|Construction:||Die-cast aluminium with tempered glass lens|
|Input Voltage:||220 - 240v ac 50-60Hz|
|Light Output:||10w 4000K Cool white LED producing 1000 Lumens|
Stirrup bracket mounts on walls or the optional E2530M ground spike.Supplied with pre-fitted 2m cable. Use supplied stainless steel fixings to attach light in desired location. Terminate cable via a suitable junction box or inline connector.
Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of a separate RDC to protect each circuit with a maximum of 12 fittings per RCD
E2530M Neptune spike mount - Black Polycarbonate.
The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees. When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match.
All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. All cable joints must be 100% watertight. There are a selection of waterproof jointing kits and boxes available on this web site.
H05RN-F 3 Core Rubber Sheathed Mains Cable 1.5mm is recommended but do not use PVC flex cable as this can cause poor connections for the cable glands/joints and will lead to capillary action.
|Materials:||Die-cast aluminium with tempered glass lens|