01689 606342

Dasar 115 adjust, GU10, ground recessed, 316 stainless steel cover, 30 degree tilt, IP67


The Dasar 115 adjust is a 316 marine grade stainless steel bezel luminaire designed for exterior ground use and is IP67.
We recommend that you use a GU10 LED lamp so the fitting is safe to touch and ECO friendly. There is a ground potting pot included with the fitting. This fitting can take a maximum load of 2 tons for a concrete installation and can be used as a drive over light. There is also 30 degree of tilt angle available and 90 degree rotation in this ground light.

LED lamps are available on this site and a selection suggested at the bottom of the page under 'Related Products' which will create a medium beam of soft light.  LED lamps have a long life, use minimal electricity and are cool to touch, making them safe around children.

Feed-in capability No. Lampholder / Socket GU10. Installation diameter 11.5 cm. Installation depth 16.5 cm. Tilt range 30 Degree. Rotation range 90 Degree.
Height 16 cm. Diameter 8 cm. Net weight 0.981 kg.  Gross weight 1.138 kg . Voltage 230 Volts. Max wattage 35 Watt.  Protection class I.  IP-rating IP 67.
Energy efficiency class A++.  Lamp GU10.  230V.  Material Aluminium / Stainless Steel 316 Colour stainless steel.
Way of mounting Inground mounting Weight capacity 2 tons.

Installation 

Please check the specification for dimensions before purchasing.


It is important that adequate drainage is allowed for when installing this type of product especially in clay based soil beds.
A NIC EIC electrical contractor should be used to ensure a 100% water tight installation. There are junction boxes, resin kits, magic gel and heat shrink kits available from us to help make the perfect waterproof joint.

For a mains 220v - 240v supply you should use SWA ( steel wired armour ) rubber cable and NOT PVC.   Each new garden supply should also be on its own RCD.

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cabling and connection joints. All joints must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix or magic gel. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas, i.e. approximately 105mm of shingle or stones.

Energy efficient lamps


Choosing the right lamp is a combination of 3 main factors, Lumen's, Kelvins and efficiency. Efficiency matters because you want the maximum light output possible (Lumen's) from the minimum amounts of watts consumed. Kelvins are the colour temperature of the lamp. 2700k is the warm end of the colour spectrum and 5000k is the cooler whiter end of the colour spectrum. The latest LED technology  lamps are amongst the most efficient you can buy today. An example would be to change a mains halogen GU10 35w lamp to a ECO friendly GU10 5w LED lamp.  Reduced energy bills with no loss of light output helps the environment and reduce your energy bills. 


Example of LED lamp energy savings



                  



Lamp colour ( Kelvin's )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 6,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 6,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. Coloured filters are good to use with the LED bulbs too especially in winter using green filters give the appearance the trees are still in leaf.


                                                          


Features


The installation pot is included 
Maximum load: 2 tons 
316 stainless steel cover
IP67

Item Specifications

colour: stainless steel
Lamp description: GU10 230 V max 35 Watt
Cut out: dia 11.5 cm
Installation depth: 16.5 cm
Overall diameter: 13 cm
Weight: 0.900 kg
Voltage: 230 Volt, 12 Volt
Max wattage: 35 Watt
IP rating: IP 67
Materials: aluminium / stainless steel 316
Height: 16cm
Degree of tilt: 30
Bulb Type: GU10
diameter: 8cm
shape: circular, Square bezel
rotation: 90 degree