01689 606342


Navigator Mono - Stainless Steel - 12v - 0.5w Warm White LED - Round. IP67


The Navigator Mono is a stainless steel step and brick light with a warm white 2700k LED which consumes a tiny amount of power and stays cool to the touch, adding a stylish modern element to a garden lighting scheme. The Navigator Mono are used to mark out the shape of a deck giving out 55 lumens to the patio or terrace or to outline paths and light small steps. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space lights about 0.8 - 1.2 metres apart.

All recessed luminaires must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds.  All cable joints must be 100% watertight and there are a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections and transformers are kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal.

Colour/Finish: 316 stainless steel is a popular choice for modern garden settings.
 IP Rating: Weatherproof to IP67 - rain & hoseproof
 Construction: Each light contains long life high-output LED resin-encapsulated behind a frosted glass lens in a stainless steel bezel.
The case has a spring mount which locates the light in a sleeve used to prepare positions in concrete, paving or walls.
They can be recessed without the sleeve in decking, sleeper walls and other materials using a 38mm wood drill bit.
 Input Voltage: 12v 0.5w:

 NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable with a heat-shrink crimped-connector weatherproof Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable) or T9963 Cable Splice Kit (for connecting into a run of cable).

NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator LED lights.
If powering from a 12v 20va or 50va ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating. Lamp Type: 1 Warm White LED; white is a safe choice for more traditional settings or where there may be reservations about using a coloured garden lighting effect Installation:

 Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit; for splicing into a run of cable use T9963 cable splice kit. Accessories: The top section can be unscrewed to allow the insertion of theatrical coloured gels to enable you to customise your garden lighting.


Step lighting example


                                        


      


Installation

MUST BE WIRED IN PARALLEL      please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit, for splicing into a run please use the T9963 kit.






KELVIN COLOUR TEMPERATURE CHART







Item Specifications

colour: stainless steel, Natural Copper
Voltage: 12 Volt
IP rating: IP 67
Bulb Type: LED
colour temperature: 4000 Kelvin, 2700 Kelvin