01689 606342


The ‘Signet’ LED path light is elegant and modern with a curved ‘swan neck’ style body.  At the top of the ‘Signet’ is a single in-built warm white 3w LED which emits a powerful light equivalent to 25w halogen (approx). The streamlined curved design makes it perfect for highlighting flower beds, pathways, edging and other lower garden features. Two finishes are available, silver grey and dark grey. The Signet is rated IP54 which means that it is suitable for areas affected by automatic garden watering systems.


This streamlined shape is perfect for lighting pathways and flowerbeds, acting as a bright LED downlight, and gives the Signet a look of elegance. With an IP rating of IP54, and with it's robust aluminium body, tidy little LED post light is ideal for use in any modern garden or outdoor area.


Aluminium,  230V,  3W,  200 Lumens,  3000K - Warm White,  IP54,  Height: 570 mm,  Dark Grey


Bollard types and spacing

Bollard lights are available in a massive choice of styles, finish and lamp options. You need to think about how the light will be used for example a small garden pathway, the main driveway or to illuminate steps etc.  If you are within 20 km of the coast you should think about using the wooden bollards or marine grade 316 stainless steel. Some bollards have built in LED lamps  and they generally offer lower levels of light ( lumen's ) than say a compact fluorescent. Also if the lamp is an integral part of the bollard then it cannot be replaced if it fails in future so you will have to purchase a complete new bollard. There are bollards that use GU10 LED lamps and in this case can be changed for a ECO friendly GU10 LED lamp. The spacing of the bollards will depend on the lamp output, louvre design, height etc but a general rule of thumb would be no less than 3 meters and no more than 12 meters apart. The shorter distance would be for garden pathways and the longer distance for long driveways.

 

 

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs.


All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. all cable joints must be 100% watertight. There are a selection of waterproof jointing kits and boxes available on this web site.







Item Specifications

Voltage: 220 - 240v
IP rating: IP 54
Materials: aluminium
Height: 570mm
Lumens: 200
Material Finish: silver grey, Dark Grey
watts: 3w
colour temperature: 3000 Kelvin
additional information: Also available in Silver Grey