01689 606342

DASAR 218 Bullseye QRB111 LED adjustable uplight


The Dasar Bullseye uplight has a 316 marine grade bezel and a 180 degree tilt and 160 degree rotation. The dimensions are 218mm diameter including the bezel and 387mm depth including the domed top.  The dome itself is 80mm in height.  The base of the fitting is 197mm in diameter.
It is IP67 adn can take a half ton load.  The beauty of this fitting is that it has great flexibility with it's tilt and rotation capacity and can be placed close to objects.

It uses G53 QR111 mains light bulbs to give maximum impact.
The bezel is 316 marine grade stainless steel.

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. 

                                                         


Installation 

All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. Also mains cable should be SWA rubber and not PVC.


All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. All cable joints must be 100% watertight. There are a selection of waterproof jointing kits and boxes available on this web site.

H05RN-F  3 Core Rubber Sheathed Mains Cable 1.5mm is recommended but do not use PVC flex cable as this can cause poor connections for the cable glands/joints and will lead to capillary action.


Item Specifications

colour: stainless steel 316
Lamp base: G53
Voltage: 220- 240v
Max wattage: 50 Watt
IP rating: IP 67