01689 606342

Dasar Exact, GU10, round, ground recessed, 316 stainless steel, IP67, 2 ton load, 30 degree tilt


The Dasar Exact GU10 is one of our most popular fittings and an ideal fitting for driveways and uplighting shrubs and small trees. This fitting can be mounted flush with the surface rather than the more traditional ones that have a raised bevel edge.

 Although It can be used with a standard GU10 mains lamp to a maximum of 35w preferably you could use a GU10 LED lamp so the fitting is safe to touch and ECO friendly. There is a ground mounting pot included with the fitting.This fitting can take a maximum load of 2 tons and can be used as a drive over light. There is also 30 degree of tilt angle available in this ground light.

Energy efficient lamps


Choosing the right lamp is a combination of 3 main factors, Lumen's, Kelvins and efficiency. Efficiency matters because you want the maximum light output possible (Lumen's ) from the minimum amounts of watts consumed. Kelvins are the colour temperature of the lamp. 2700k is the warm end of the colour spectrum and 5000k is the cooler whiter end of the colour spectrum. The latest LED technology lamps are amongst the most efficient you can buy today. An example would be to change a mains halogen GU10 35w lamp to a ECO friendly GU10 5w LED lamp. Reduced energy bills with no loss of light output helps the environment and reduce your energy bills. 

Example of LED lamp energy savings




              


Lumen chart

                     
                                                                                                   
 


Installation 

Please check the specification for dimensions before purchasing.


It is important that adequate drainage is allowed for when installing this type of product especially in clay based soil beds.
A NIC EIC electrical contractor should be used to ensure a 100% water tight installation. There are resin kits, magic gel and heat shrink kits available from us to help make the perfect waterproof joint.

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix or magic gel. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas.   Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs.


Features

The installation pot is included 
Maximum load: 2 tons 
316 stainless steel cover
IP67
30 degree tilt

Item Specifications

colour: stainless steel brushed
Lamp base: GU10
Lamp description: GU10 230 V max 35 Watt
Cut out: dia 11.6 cm
Installation depth: 17 cm
Overall diameter: 11.6 cm
Weight: 0.960 Kg
Voltage: 230 Volt, 12 Volt
Max wattage: 35 Watt
IP rating: IP 67
Materials: aluminium / stainless steel 316
Depth: 16 cm
Degree of tilt: 30
Bulb Type: GU10
shape: circular, Square bezel