01689 606342

Dasar quadro square, GU10, ground recessed,

304 stainless steel cover, 30 degree tilt, IP67

This is a aluminium body fitting with a 304 stainless steel top cover, designed for exterior ground use and is IP67 ( see guide under design ideas )
It can be used with a standard mains GU10 lamp to a maximum of 35w or you could use a GU10 LED lamp so the fitting is safe to touch and ECO friendly.There is a ground potting pot included with the fitting.This fitting can take a maximum load of 2 tons and can be used as a drive over light. There is also 30 degree of tilt angle available in this ground light.

LED lams are available on this site and also a GU10 fluorescent which will create a very wide beam of soft light.  LED lamps have a long life, use minimal electricity and are cool to touch, making them safe around children

Energy efficient lamps

Choosing the right lamp is a combination of 3 main factors, Lumen's, Kelvins and efficiency. There are other factors but not so relevant for exterior lighting products.  Efficiency matters because you want the maximum light out put possible ( Lumen's ) from the minimum amounts of watts consumed. The latest LED technology and compact fluorescent lamps are amongst the most efficient you can buy today. An example would be to change a mains halogen GU10 35w lamp to a ECO friendly GU10 5w LED lamp. The same be done by changing the older GLS light bulb for a compact fluorescent lamp. Reduced energy bills with no loss of light output helps the environment and reduce your energy bills. 

LED lamp savings



Please check the specification for dimensions before purchasing.

It is important that adequate drainage is allowed for when installing this type of product especially in clay based soil beds.
A NIC EIC electrical contractor should be used to ensure a 100% water tight installation. There are resin kits and heat shrink kits available from us to help make the perfect waterproof joint

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.


The installation pot is included 
Maximum load: 2 tons 
316 stainless steel

Item Specifications

colour: stainless steel
Lamp base: GU10
Lamp description: GU10 230 V max 35 Watt
Cut out: 12.4 x 12.4 cm
Installation depth: 13.5 cm
Weight: 1.150 kg
Voltage: 230 Volt
Max wattage: 35 Watt
IP rating: IP 67
Materials: aluminium / stainless steel 316
Suggested lamp: 575351
Length: 13 cm
Width: 13 cm
Height: 12 cm
Degree of tilt: 30