01689 606342

Dolix Out, outdoor square, GU10, silver grey, frosted front glass, IP44


The Dolix Out range is available in low voltage MR16 or mains voltage GU10 and a number of colour options.

Can be used in soffits, porches, exterior ceiling voids. When lighting is fixed into the soffit boards great lighting effects can be created that wash the walls with light. Narrow beam lamps and coloured lamps can also be used to make more of a decorative effect if desired. Some soffit recessed lighting can be relamped from above and below to make maintenance easier. Wiring regulations would suggest that a ingress protection of IP23 would be sufficient in this location but using a fitting with a higher IP figure can only ensure extra protection in exposed locations.

Where depth is available they can also be used in an entrance porch linked to a motion detection PIR so they come on only when required. 
 

Energy saving LED lamps

The use of energy efficient LED  lamps are long lasting and therefore ideal for areas where access is a problem and regular lamp changes would not be desirable.

                       
 

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs. 

IP Rating

All the luminaires on our web site have been specifically designed fit for purpose and assigned a relevant IP rating which denotes the amount of protection that is required from water and dust. More information on IP ratings can be found in the design ideas section on this web site.


Features

Ceiling thickness max 15mm
IP44
Can use LED lamps
Depth 130 mm
Cut out 70mm


Item Specifications

colour: titanium, chrome, white, Silver Grey
Lamp base: GU10
Lamp description: GU10 230 V max 35 Watt
Cut out: dia 7 cm
Installation depth: 13 cm
Weight: 0.300 kg
Voltage: 230 Volt, 12 Volt
Max wattage: 35 Watt
IP rating: 44
Materials: aluminium / glass
Length: 9 cm
Width: 9 cm
Bezel: Round Bezel, Square Bezel