This product is low in stock. Please call the office.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light. Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.
All the luminaires on our web site have been specifically designed fit for purpose and assigned a relevant IP rating which denotes the amount of protection that is required from water and dust. More information on IP ratings can be found in the design ideas section on this web site.
|colour:||chrome, white, titanium, Silver Grey|
|Lamp description:||GU10 230 V max 35 Watt|
|Cut out:||dia 7 cm|
|Installation depth:||13 cm|
|Overall diameter:||8 cm|
|Voltage:||12 Volt, 230 Volt|
|Max wattage:||35 Watt|
|Materials:||aluminium / glass|
|Bezel:||Round Bezel, Square Bezel|