All the luminaires on our web site have been specifically designed fit for purpose and assigned a relevant IP rating which denotes the amount of protection that is required from water and dust. More information on IP ratings can be found in the design ideas section on this web site.
Light levels are measured in something called LUX. Put simply LUX is a measurement of light falling on a given surface area. For example an average LUX of 200 would be needed for an outdoor tennis court for recreational purposes and a side street walkway would have an average of 5 LUX. To calculate lux levels you need a very good calculator or computer as there is a number of factors that need to be taken in to account.
Sunny June day 80000 Lux
Bad light stopped play at Lords 1000 Lux
A well lit office 500 Lux
Main road lighting 15 Lux
A residential side street 5 Lux
A clear moonlit night 0.2 Lux
Please ensure that you use use a PART P, NIC EIC certified electrical contractor.
Choosing the style of a product is only part of the equation you must also think
of where that product will be used and how it will be installed. All exterior lighting
products on our web site have a IP rating which is explained further in our design
ideas section but in simple terms the IP rating is appropriate to each light fitting
and its intended application and is therefore fit for purpose. Water ingress is the
enemy for outdoor lighting and the products supplied are only as good as the installation
as the weakest point is always cable and transformer joints. All joint must be made
100% water tight and this can be done using heat shrink kits, waterproof junction
boxes which are then filled with a resin mix. All joints where possible should be
made above ground for easy access and reduced water ingress. When installing ground
buried lights adequate drainage systems should be put in place especially in clay
based soil areas. If possible use ground surface spike lights rather than a buried
light. Mains 240v cable will have less joint than a low voltage installation
but care must be taken with the cable runs.
Care should be taken for local wildlife, insects, and general light pollution, this means the warmer colour spectrum does not interfere with insects and general wildlife as much as the blue spectrum of light around 6,000 kelvins which can disrupt their normal night time activity. This also applies to bats where a anti glare light fittings works better as well as reducing overall light pollution in the area.
Low voltage control gear built in
Made in Germany
Can use led lamp option
|Lamp description:||MR16 12 V max 50 Watt|
|Overall diameter:||5.7 cm|
|Max wattage:||50 Watt|
|IP rating:||IP 44|
|Degree of tilt:||45|