01689 606342

E8961ARG 
Groundlighter is a 12v AR111 recessed light designed for uplighting smaller trees or statues and other features in waterlogged lawns and other wet locations. It is available with a plain rim and flush lens which sheds water and leaf litter for reduced maintenance, or with a protective grill for use in walkover areas to protect against a hot lens. Robust cast-brass construction is corrosion-resistant for use in all soil types. The advantage of a AR111 lamp is it's controlled beam angle and wide reflector. Lamps with a tight 8 degree beam angle can be used to create a pencil beam of light up a column or building facade or to illuminate tall thin trees.

All recessed luminaires must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joint must be 100% watertight and there a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections and transformer be kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal.

Colour/Finish
Cast brass

IP rating
IP68

Construction
Cast brass body and lens bezel secured by stainless steel screws with 8 screw fixings for even gasket pressure and flush tempered clear glass to shed water. Pre-wired with 6 metre cable

Input voltage
12 volts; requires supply from a transformer

Lamp type
AR111 lamp or MR16 lamp with E8960MR converter.

Installation
Direct connection to a transformer or junction box via cable fitted or connection of fitted cable to low voltage supply cable by crimped heat shrink joint - order cable splice kit T9963 separately when using 4mm low voltage cable recommended for 75w recessed uplights

Accessories
Clip-on honeycomb glare filter and colour filters may be fitted on front of the MR16 lamp inside the light simply by removing the clip to create a range of lighting effects. For example MR16ASL converts a round beam to a more rectangular distribution to increase lateral or vertical