01689 606342

Delwa wall LED, curved wall light, cool white + blue LED, silver housing, 6,500 kelvin cool white light, 170 lumen's

This is a very modern and unique styled light fitting which can be used to shine light up or down with a wide beam distribution. It also has a clear slot where a blue light can be seen and creates a stunning effect at night. Good for a wall wash effect or to illuminate a walkway. Ultra slim ECO friendly LED technology light fitting with the main light source in 6,500 Kelvin cool white 5w and a 1w LED blue slot light. Very wide cool white beam distribution with good anti glare properties. The main lamp produces 170 lumen's of light. would suit a modern contemporary style of property. The addition of the the thin blue LED line on the fitting adds to it's appeal and stand out from the standard style wall lights.

Lamp colour ( Kelvins )

Lamp colour works in Kelvins and a standard house hold lamp may be 2700 kelvin which is at the warm white spectrum and good for skin tones and a relaxing soft light. At the other end of the spectrum 6500 kelvin would be a very cool blueish type of light that will appear brighter to the naked eye at night and good against white wash walls but not good for skin tones as the would appear greyish and washed out.


Light output ( Lumen's )

The amount of light that is produced by a lamp is called lumen's and the more lumen's the lamp has the brighter it will be. Lumen's work in conjunction with kelvins and should not be taken in isolation of each other, for example if you had a very warm white lamp at 2,700 kelvins and it produced 300 lumen's and you then had another lamp which was a cool white 6,000 kelvins which also produced 300 lumen's the cooler lamp colour would always appear brighter to the naked eye than the warmer one this is due to the receptors in the eye that react better to a white light spectrum. Another factor on how bright a light may appear is contrast so if you shine a white 6,000 kelvin light on to a dark wall and a warm 2,700 kelvin lamp on to a white wall the warmer lamp would appear brighter due to the contrast of the material it is focused on. So when choosing a lamp always take in to account the area you want to illuminate and think about Kelvins ( colour ),  Lumen's ( brightness) and contrast  ( colour of area )


First and foremost all new external electrical works must be installed by a PART P registered electrical contractor. The contractor must supply you with full certification once the work is completed.  For a mains 240v supply they should use SWA ( steel wired armour ) cable. If a 12v low voltage system is being installed then flexible rubber round double insulated cable can be used ( NOT PVC CABLE ). Each new garden supply should also be on its own RCD. Cable should be buried to a safe depth to avoid any unnecessary risk due to garden forks or spades.

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.


Including a built-in LED driver
The front slit is lit up with a blue 1 watt power LED for a ascetically pleasing appearance.
The light source is  very cool white and would suit a white wall background for maximum effect
Slim body
Quality German made
Integral gear and lamp

Item Specifications

colour: silvergrey
Lamp description: Power LED 5 Watt
Weight: 0.450 kg
Voltage: 230 Volt
Max wattage: 6 Watt
IP rating: IP 44
Materials: aluminium / glass
Width: 6 cm
Height: 18 cm
Depth: 6.4 cm