01689 606342


LED OUTDOOR BEAM, silver grey, 10W, warm white, 100° beam angle, 90° tilt



including an incorporated LED driver
emitting angle 100°
connection lead: 200 cm
Lamp lumen output 750 lm using a 1 piece module COB LED

Multi purpose quality built product which can be mounted on a wall, bolted to a concrete floor or spiked in soft ground with the additional spike 900011

High output LED lamp that is eco friendly and long lasting.

The wide beam angle makes this a good security or localised flood light.

A good quality silicon gasket keeps water at bay and is IP65 rated.

The wide beam angle is ideal to up light building facades or trees when floor mounted or to illuminate a wide area when mounted on a spike.

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.


All exterior lights must be installed by a certified NIC EIC electrical contractor and all cable joints must be 100% watertight. There are a selection of waterproof jointing kits and boxes available on this web site.










Item Specifications

Beam Angle: 100°
colour: silvergrey
Weight: 0.500 kg
Voltage: 230 Volt
Max wattage: 10 Watt
IP rating: IP 65
Materials: aluminium
Suggested accessories: 900011
Width: 11.5 cm
Height: 13 cm
Depth: 9 cm
Degree of tilt: 90
Lumens: 750 lm
Kelvin: 3000k, 5700k