01689 606342


LED Flood Light 10W Warm White IP65 With PIR Sensor (80 Watt Alternative)


Very low energy security flood light with integral PIR which is adjustable for tilt and rotation. 5 meter coverage.

Designed to replace the traditional 80w halogen flood light with a massive energy saving, instant start and long life. The warm white lamp is around 3000 kelvins and ideal as a security light.

The fitting comes complete with its own wall bracket which enables the light fitting to have a degree of tilt.

The shape of the internal reflector means it throws a symmetrical wide beam of light and must be angled down to avoid any direct glare or upward light spill.

 

Installation


All exterior lighting products on our web site have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. 


All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. 

H07RN-F H07 3 Core Rubber Sheathed Mains Cable 1.5mm is recommended but do not use PVC flex cable as this is a poor connection for the cable glands and will lead to capillary action.

Lamp colour ( Kelvins )


The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. 


     

Light output ( Lumens )


The amount of light that is produced by a lamp is called lumen's and the more lumen's the lamp has the brighter it will be. Lumen's work in conjunction with kelvins and should not be taken in isolation of each other, for example if you had a very warm white lamp at 2,700 kelvins and it produced 300 lumen's and you then had another lamp which was a cool white 5,000 kelvins which also produced 300 lumen's the cooler lamp colour would always appear brighter to the naked eye than the warmer one this is due to the receptors in the eye that react better to a white light spectrum. Another factor on how bright a light may appear is contrast so if you shine a white 5,000 kelvin light onto a dark wall and a warm 2,700 kelvin lamp onto a white wall the warmer lamp would appear brighter due to the contrast of the material it is focused on. So when choosing a lamp always take into account the area you want to illuminate and think about Kelvins ( colour ),  Lumen's ( brightness) and contrast  ( colour of area ) .

Environmental impact


Care should be taken for the environment and local wildlife to maintain the ecological balance. Insects, bats and other types of wildlife can all be effected by light pollution. The warmer colour spectrum of  2,700 kelvins does not interfere with insects and general wildlife as much as the blue colour spectrum of light around 5,000 kelvins which can disrupt their normal night time activity. This also applies to bats where anti glare light fittings work better as well as reducing the overall light pollution in the area. You must also be mindful of your neighbours and the effect your lighting can have on them. Try to keep the light in a downward position and local to the items you want to illuminate and even if you want to illuminate tall trees it can be done in a sympathetic way by placing a ground buried or surface spike flood light directly under the trees to illuminate the canopy.


Item Specifications

colour: black
Voltage: 220 - 240v
IP rating: IP 65
Length: 115mm
Width: 85mm
Depth: 85mm
Bulb Included: Yes
Lumens: 800 lm
Bulb Type: LED
Lamp Watts: 10w
lamp life: 30,000 hrs
colour temperature: 3000 Kelvin