01689 606342

Maxigot up and down light, black, IP65, 70w metal halide


The Maxigot is an exterior cylindrical surface wall mounted luminaire providing direct and indirect light. It has a metal halide light source for powerful and intense light projection and is suitable for commercial applications.

Very high output of light 6,3000 lumens energy efficient and lamp life of around 8,000 hours


Metal halide lamps are used in many commercial application due to their high output and low wattage compared to other lamp sources. Lamps can be warm white 27000k or cool white 4000k.  The nature of the lamp and built in control gear means you can not simply switch these on and of like a standard lamp source. They need time to start up and run up to full power and when switched of there is a cooling down period of about 7 minutes before you can turn them on again. The lamp has a life span of around 8,000 hours which makes it very economical. Other metal halide light fittings would be ground buried lights and ground spike lights like the Apollo range which are used to illuminate large trees and building facades.


A medium beam distribution is created up and down and works well as a wall wash light fitting to highlight the side of a building and illuminate the pathway below.

Lamp colour ( Kelvins )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 6,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm coulour wavelength helps to soften skin tones and gives a warm soft relaxed feel and at the other end of the scale a 4,000 to 6,000 kelvin lamp colour  would be used in offices or a fast food restaurants to make you feel less comfortable and relaxed and more alert. There‚Äôs nothing that can sour your opinion of a compact fluorescent  or LED lamp like buying a 4000K or 5000K bulb when you meant to buy a 2700K bulb, or vice-versa. When you buy a new, energy efficient bulb, keep your application and color scheme in mind and make sure to buy the bulb with a color temperature to match.

Light output ( Lumens )

The amount of light that is produced by a lamp is called lumens and the more lumens the lamp has the brighter it will be. Lumens work in conjunction with kelvins and should not be taken in isolation of each other, for example if you had a very warm white lamp at 2,700 kelvins and it produced 300 lumens and you then had another lamp which was a cool white 6,000 kelvins which also produced 300 lumens the cooler lamp colour would always appear brighter to the naked eye than the warmer one this is due to the receptors in the eye that react better to a white light spectrum. Another factor on how bright a light may appear is contrast so if you shine a white 6,000 kelvin light on to a dark wall and a warm 2,700 kelvin lamp on to a white wall the warmer lamp would appear brighter due to the contrast of the material it is focused on. So when choosing a lamp always take in to account the area you want to illuminate and think about Kelvins ( colour ),  Lumens ( brightness) and contrast  ( colour of area )

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.

Energy efficient lamps

Choosing the right lamp is a combination of 3 main factors, Lumens, Kelvins and efficiency. There are other factors but not so relevant for exterior lighting products.  Efficiency matters because you want the maximum light out put possible ( Lumens ) from the minimun amounts of watts consumed. The latest LED technology and compact fluorescent lamps are amongst the most efficeint you can buy today. An example would be to change a mains halogen GU10 35w lamp to a ECO friendly GU10 5w LED lamp. The same be done by changing the older GLS light bulb for a compact fluorescent lamp. Reduced energy bills with no loss of light output helps the environment and reduce your energy bills.

IP Rating

All the luminaires on our web site have been specifically designed fit for purpose and assigned a relevant IP rating which denotes the amount of protection that is required from water and dust. More information on IP ratings can be found in the design ideas section on this web site.

Features

Quality built item that will last years.  
Suitable for outdoor use
Complete with fixing accessories
Textured black powder coat

Item Specifications

Voltage: 240V
IP rating: 65
Suite Name: Maxigot
Product Type: Non Automatic
Zone: Outdoor
Finish: Textured black paint & clear glass
Dimensions: 280mm height x 280mm projection x 180mm width
Material: Cast alloy & glass
Bulb Category Primary: HID
Bulb Included: No
Bulb Light Source Description: 1 x 70W G12 T (HCIT)
Dimmable: Non-dimmable
Benefit: Suitable for indoor or outdoor use
Feature: Complete with fixing accessories Textured black pa
Technical: Complete with integral magnetic gear 1 x 70W G12 T
Control Gear Required: Included
Control Gear Used: Magnetic Gear