01689 606342


Mervaled S 14w LED warm white 3000k floodlight in Anthracite comes with PIR


This Powerful LED outdoor spot called the MERVALED S is great for illuminating driveway areas and rear garden areas. By means of the adjustable lamp head and its IP54 protection, the spot is suitable for exterior wall mounting. The incorporated motion sensor can be switched between day and night mode as well as low and high lux light sensitivity. The electrical connection of the luminaire, which is available in warm white colour, temperature can be fitted directly to the 230V mains supply thanks to the built-in 300mA LED driver. This luminaire contains a 14w built-in LED lamp module. EEI A - A++ The LED module in the luminaire cannot be replaced but the life of the module is rated at 30,000 hours. The floodlight gives out 750 lumens so it gives excellent light output.

The fitting is made from aluminium/ acrylic and glass and is in an anthracite colour finish. 

It has a 90 degree beam angle and can rotate 340 degrees and tilt 180 degrees.

The coverage of the light will cover 8 meters and the settings on the PIR will allow a minute on time of 5 seconds and maximum on time of 8 minutes. 

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. 


                                                         


Installation 


All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. 

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. all cable joints must be 100% watertight. There are a selection of waterproof jointing kits and boxes available on this web site.

H07RN-F H07 3 Core Rubber Sheathed Mains Cable 1.5mm is recommended but do not use PVC flex cable as this can cause poor connections for the cable glands/joints and will lead to capillary action.



Item Specifications

Beam Angle: 90 degree
colour: anthracite
Voltage: 220 - 240v
IP rating: IP 54
Materials: aluminium / acrylic glass
Width: 14 cm
Height: 26.5 cm
Depth: 22.5 cm
Degree of tilt: 180 degree
Sensor: PIR, None
Lumens: 750 lm
Bulb Type: LED
watts: 14 Watt
additional information: 300mA driver included
rotation: 340 degrees