Modula ground, 30 degree adjustable, up light, round, Textured brass, 12v, IP67
E8761N is a stylish 12v recessed up-light with a choice of 20-50w halogen lamp or low energy LED lamp. Modula is fitted with
a flush lens as standard. The light is located by an O ring on the body into a sleeve tube. To facilitate removal of screws
for future re-lamping or other maintenance, apply copper grease to the threads of all screws being fitted for retention of
bezels, grills or other top plates or retaining rings. Copper grease resists degradation due to heat and protects against
difficulty in removing screws, particularly where stainless steel screws are fitted with aluminium parts. It may also be
used on screw threads of screw-off bezels or glare shields. Ensure surplus is cleaned off with a solvent to prevent staining
in use.
Colour/Finish: |
Fine sandblasted cast brass finish looks good on decking, timber, sandstone and buff brick |
IP Rating: |
IP67 |
Construction: |
Front bezel is attached to tubular aluminium body. 1m cable via rear entry cable gland |
Input Voltage: |
12v |
Lamp Type: |
MR16 20w or 50w halogen lamp or MR16 L.E.D. lamps include white or warm white 3w or 5w; 50,000 life and low
energy consumption make them a popular option |
Installation: |
The plastic sleeve is built in during construction or retrofitted into a hole cut with a coring bit: the
light pushes into the tube, where it is held firmly in place by an o-ring. Connect input cable to cable
from transformer using T9962 cable joint or T9963 cable splice kit.
|
LED energy saving example

All recessed luminaires must have adequate drainage beneath each fitting to allow
water to disperse, especially in clay based soil beds. All cable joint must be 100%
watertight and there a number or waterproof transformer boxes and heat shrink cable
joint kits on our web site to choose from. We would advise that all connections and
transformer be kept above ground where possible as the weakest link in any exterior
garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting
installations before.
Typical loading on a transformer

Colour/FinishFine sandblasted cast brass finish looks good on decking, timber, sandstone and buff brick
IP ratingIP67
ConstructionFront bezel is attached to tubular aluminium body. 1m cable via rear entry cable gland
Input voltage12v
Lamp typeMR16
20w or 50w halogen lamp or MR16 LED modules include white or warm white
3w or 5w; 50,000 life and low energy consumption make them a popular
option
InstallationThere is space inside the
body to fit a clip-on MR16 spread lens or colour filter accessory onto
the front of the lamp. E8700FLN Modula frosted lens may be fitted for
softer, more diffused lighting effects.