Navigator Maxor - Textured Brass - 12v - Round - cool white, 4,000 kelvin's,
E3361WW is a low energy, warm white l.e.d. deck and recessed light which consumes
a small amount of power and stays cool to the touch. The warm white led produces
a wide 800 beam diffused by the 28mm diameter frosted lens to provide soft lighting
compatible with the colour of halogen garden lighting. Navigator Maxor are used either
to mark out the shape of a deck, patio or terrace, to outline paths and to light
steps. To outline a deck or patio space with a distinctive shape, start at the corners
of the decking or paving and space led recessed garden lights at about 1 - 1.5m apart.
All recessed luminaries must have adequate drainage beneath each fitting to allow
water to disperse, especially in clay based soil beds. All cable joint must be 100%
watertight and there a number or waterproof transformer boxes and heat shrink cable
joint kits on our web site to choose from. We would advise that all connections and
transformer be kept above ground where possible as the weakest link in any exterior
garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting
installations before. Also ensure that all rubber gaskets are clean and dry before
screwing down the front glass and bezel for a water tight seal.
Step lighting example
Fine sandblasted brass finish looks good on decking, timber, sandstone and buff brick
IP67 see design ideas section for more details
life high-output l.e.d resin-encapsulated behind a frosted glass lens
in a stainless steel case. The case has a spring mount which locates the
light in a sleeve used to prepare positions in concrete, paving or
walls. They can be recessed without the sleeve in decking sleeper walls
and other materials using a 44mm hole saw. Diameter 60mm (sleeve 48mm;
44mm cut-out without sleeve) recess depth 75mm.
12v 2.2W (
): NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable
with a heat-shrink crimped-connector weatherproof
Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable)
or T9963 Cable Splice Kit (for connecting into a run of cable).
NAVIGATORS should be powered by 12v dc power supply. Do not use an
electronic transformer to power Navigator led lights. If powering from a
12v 20va or 50va ac wire-wound transformer, ensure transformer is
loaded to at least 75% of nominal rating.
Transformer loading example
( NOT WIRED IN PARALLEL )
Lamp type1w warm white led. 2.2w
MUST BE WIRED IN PARALLEL
please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint
kits and 1.5mm cable, which is more flexible than kit-type products.
Connect to the end of a low voltage cable using T9962 cable joint kit;
for splicing into a run of cable use T9963 cable splice kit.
The top section of this l.e.d. light can be unscrewed to allow the insertion of theatrical coloured gels to
enable effect lighting