Navigator Minor led light - Textured Brass - 12v - Round - cool white 4,000 kelvin, led 0.3w
E3161W is a white l.e.d. deck and recessed light which consumes a tiny amount of power and stays cool to the touch. The 0.3w led produces a wide 80 degree beam angle diffused by the 16mm diameter frosted lens. They are used either to mark out the shape of a deck, patio or terrace, to outline paths and to provide marker lighting in step risers. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space led recessed garden lights at about 60cm - 1m apart in step risers, space them about 60cm apart along the centre line of the riser
All recessed luminaries must have adequate drainage beneath each fitting to allow
water to disperse, especially in clay based soil beds. All cable joint must be 100%
watertight and there a number or waterproof transformer boxes and heat shrink cable
joint kits on our web site to choose from. We would advise that all connections and
transformer be kept above ground where possible as the weakest link in any exterior
garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting
installations before. Also ensure that all rubber gaskets are clean and dry before
screwing down the front glass and bezel for a water tight seal.
Step lighting example
Fine sandblasted cast brass finish looks good on decking, timber, sandstone and buff brick
IP ratingIP67, see design ideas section about IP ratings
Each light contains long life high-output l.e.d resin-encapsulated behind a frosted glass lens in a stainless steel case. The case has a spring mount which locates the light in a sleeve used to prepare positions in concrete, paving or walls. They can be recessed without the sleeve in decking, sleeper walls and other materials using a 28mm wood drill bit. Diameter 40mm (sleeve 32mm; 28mm cut-out without sleeve) recess depth 75mm. The top section can be unscrewed to allow insertion of theatrical coloured gels.
12v 0.5w:( TOTAL LOADING
) NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable with a heat-shrink crimped-connector weatherproof Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable) or T9963 Cable Splice Kit (for connecting into a run of cable). NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator led lights. If powering from a 12v 20va or 50va ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating.
1 X 0.5w
TOTAL LOADING white l.e.d
MUST BE WIRED IN PARALLEL
please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit, for splicing into a run of cable use T9963
80 degree beam angle
12v / 0.3w
Wire in parallel