01689 606342

Navigator Mono led light - copper - 12v - Round - white led 0.6w, cool white 4,000 kelvin's


E3221WNN is a white l.e.d deck and recessed light which consumes a tiny amount of power and stays cool to the touch, adding a stylish modern element to a garden lighting scheme. Navigator Major are used to mark out the shape of a deck, patio or terrace, to outline paths and light small steps. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space lights about 0.8 - 1.2 metres apart

All recessed luminaires must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joint must be 100% watertight and there a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections and transformer be kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal.

Step lighting example

                             

Colour / Finish

coper is a smart choice for traditional gardens and red brick work

IP rating

Weatherproof to IP67 - rain & hose proof

Construction

Each light contains long life high-output l.e.d’s resin-encapsulated behind a frosted glass lens in a stainless steel bezel. The case has a spring mount which locates the light in a sleeve used to prepare positions in concrete, paving or walls. They can be recessed without the sleeve in decking, sleeper walls and other materials using a 38mm wood drill bit

Input voltage

12v 1 x 1w ( TOTAL LOADING IS 1w ): NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable with a heat-shrink crimped-connector weatherproof Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable) or T9963 Cable Splice Kit (for connecting into a run of cable). NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator led lights. If powering from a 12v 20va or 50va ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating.

Lamp type

0.6w but 1w total loading, cool white l.e.d.’s

Installation

MUST BE WIRED IN PARALLEL please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit, for splicing into a run please use the T9963 kit


        

Accessories

Top section can be unscrewed to allow insertion of theatrical coloured gels to custom your lighting scene

Item Specifications

colour: stainless steel, Natural Copper
colour temperature: 4000 Kelvin, 2700 Kelvin