01689 606342

Polus Asymmetric LED Recessed Spotlight 24v DC 9w 316 Stainless Steel


Low voltage 24v DC Polus Asymmetric outdoor LED recessed light with a warm white, 600 lumen output. IP67 outdoor LED recessed lighting with a built-in LED suitable for wall washing, illuminating statues and at the base of trees - where beam control is a key consideration.

Polus Asymmetric outdoor LED spotlights are designed for lighting small trees and facades from a close position.  The Polus is a high quality, LED recessed lighting fixture with an asymmetric reflector capable of projecting a medium 45° beam upwards to light a tree canopy or facade while still providing coverage at the base. Also suitable to use as an outside recessed LED light, positioned at the foot of an outside wall, and being particularly effective at guarding against glare and where the control of the light spread is important. Purchase transformer separately.      

Stainless steel top plate is attached to tubular aluminium body which push fits into the aluminium tube, where it is held firmly in place by an o-ring, leaving a front plate with no visible fixing screws. 1.5m cable via rear entry cable.

Sleeve height 95mm x 66mm diameter.
Fitting depth 70mm x 78mm diameter bezel.

9w 24v DC constant voltage fitting in 316 Stainless steel, giving out 600 lumens from the 9w warm white 2700k LED.

Stainless steel top plate is attached to the tubular aluminium body which push fits into the aluminium tube, where it is held firmly in place by an 0-ring, leaving a front plate with no visible fixing screws. 1.5m cable via rear entry cable..

The aluminium sleeve is built into the floor/paving during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an o-ring, leaving a front plate with no visible fixing screws. Suitable drainage should be provided below each fitting to prevent water logging. Connect input cable to cable from transformer using T9962 cable joint or T9963 cable splice kit or T9969 underground joint kit.

1.5 metres of 2 core cable fitted for connection to a transformer or to a cable from a transformer using T9962 cable joint kit or T9963 cable splice kit.

3 Year warranty with the following exclusions: Damage by machinery, animals or the use of incorrect cleaning materials. Damage due to incorrect installation practices. Responsibility for 3rd party cost: indirect or consequential loss.

Installation 


All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas


Lamp colour ( Kelvins )
 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour                    temperature to match.      

                                                    


Item Specifications

Beam Angle: 45 Degree
colour: stainless steel 316
Voltage: 24v DC constant voltage
IP rating: IP 67
Length: 70mm
Dimensions: sleeve 95mm height and 66mm diameter
Lumens: 600 lm
diameter: 78mm
watts: 9w
lamp life: 50000 hours
colour temperature: 2700 warm white