Light levels are measured in something called LUX. Put simply LUX is a measurement of light falling on a given surface area. For example an average LUX of 200 would be needed for an outdoor tennis court for recreational purposes and a side street walkway would have an average of 5 LUX. To calculate lux levels you need a very good calculator or computer as there is a number of factors that need to be taken in to account.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light. Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.
|IP rating:||IP 65|
|Materials:||2.5mm Anodised Aluminium Body|
|Suggested accessories:||250mm Extension rod included, None|
|Length:||250mm Spike Length|
|Dimensions:||Dimensions excluding spike (L) 140mm x (W) 60mm x (H) 60mm|
|cabling:||5m of H05RNF cable|