Smoothie recessed light - textured brass - 240v GU10
E8062 is a stylish 240v recessed stainless steel light for illuminating steps or
patios with a choice of 20-35w halogen lamp, low energy led module or GU10 compact
fluorescent lamp. Smoothie is fitted with a flush frosted lens as standard to diffuse
the lighting. The light is located by an O ring on the body into a sleeve tube
so that no external screw fixings are visible. Remember that recessed step lights
are in effect recessed spotlights - avoid using them facing viewpoints to reduce glare.The edge
or the fitting has a slight bevel edge to it which adds to the
aesthetical effect of the luminaire and makes it safe to walk over. The front bezel
unscrews for easy lamp replacement and cleaning.Can be used with a GU10 LED lamp to reduce heat and electricity bills.
Remember that recessed step lights are in effect recessed spotlights - avoid using
them facing viewpoints.
Lighting steps example
Colour / Finishtextured brass, ideal for both modern and traditional properties
IP ratingIP66 see more details on IP ratings in our design ideas page
bezel is attached to tubular aluminium body which unscrews into 2
halves without tools for easy lamp changing. 1m cable via rear entry
20w or 35w halogen lamp 38 degree beam for wider staircases or 60
degree beam for wider coverage of a narrower staircase, path or patio.
GU10 warm white LED lamps include 3w for lighting across wider steps;
50,000 life and low energy consumption make them a popular option
plastic sleeve is built into the wall during construction or
retrofitted into a hole cut with a coring bit: the light pushes into the
tube, where it is held firmly in place by an o-ring, leaving a front
plate with no visible fixing screws. Suitable drainage should be
provided below each fitting to prevent water logging. Smoothies should
not be installed in ground subject to water logging, an IP68 light such
as a Atlantus Recessed light should be considered.
recessed luminaires must have adequate drainage beneath each fitting to
water to disperse, especially in clay based soil beds. All cable joint
must be 100%
watertight and there a number or waterproof transformer boxes and heat
joint kits on our web site to choose from. We would advise that all
connections be kept above ground where possible as the weakest link in
garden electrical installation is joining cables together. Magic gel and two part resin mixes can be poured in to cable joint boxes for a 100% water tight finish.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting
installations before. Also ensure that all rubber gaskets are clean and dry before
screwing down the front glass and bezel for a water tight seal. We would suggest
you use a copper grease on the fixing screws to reduce corrosion and make life easier
when you need to remove the bezel.