01689 606342

SXL II floodlight, 1 x 26w compact fluorescent, E27, black


The SXL is our premium range of exterior security and amenity flood lights. Made in Germany the offer quality and value for money. 

The SXL 2 flood light is a very ECO friendly energy efficient single  26w compact fluorescent luminaire which will throw a wide beam of light ideal to illuminate building facades, use as a security light and light up garden trees if mounted to the ground. Available in black or silver powder coated finish. The control gear is electronic which means instant start to the lamps and prolonged life span. The fitting can be linked to a photocell sensor for intruder protection. There is an adjustable stirrup bracket with 3 fixing holes and an extended arm can also be used if required for more flexibility. A gland is built in to the base of the fitting for easy cable termination. Four front fixing screws to with gasket for a watertight seal. Please use copper grease on the screw fixings to help reduce corrosion. 


Lamp colour ( Kelvins )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 6,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm coulour wavelength helps to soften skin tones and gives a warm soft relaxed feel and at the other end of the scale a 4,000 to 6,000 kelvin lamp colour  would be used in offices or a fast food restaurants to make you feel less comfortable and relaxed and more alert. There‚Äôs nothing that can sour your opinion of a compact fluorescent  or LED lamp like buying a 4000K or 5000K bulb when you meant to buy a 2700K bulb, or vice-versa. When you buy a new, energy efficient bulb, keep your application and color scheme in mind and make sure to buy the bulb with a color temperature to match. 

      


Light output ( Lumens )

The amount of light that is produced by a lamp is called lumens and the more lumens the lamp has the brighter it will be. Lumens work in conjunction with kelvins and should not be taken in isolation of each other, for example if you had a very warm white lamp at 2,700 kelvins and it produced 300 lumens and you then had another lamp which was a cool white 6,000 kelvins which also produced 300 lumens the cooler lamp colour would always appear brighter to the naked eye than the warmer one this is due to the receptors in the eye that react better to a white light spectrum. Another factor on how bright a light may appear is contrast so if you shine a white 6,000 kelvin light on to a dark wall and a warm 2,700 kelvin lamp on to a white wall the warmer lamp would appear brighter due to the contrast of the material it is focused on. So when choosing a lamp always take in to account the area you want to illuminate and think about Kelvins ( colour ),  Lumens ( brightness) and contrast  ( colour of area ) 

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.

Energy efficient lamps


Choosing the right lamp is a combination of 3 main factors, Lumens, Kelvins and efficiency. There are other factors but not so relevant for exterior lighting products.  Efficiency matters because you want the maximum light out put possible ( Lumens ) from the minimun amounts of watts consumed. The latest LED technology and compact fluorescent lamps are amongst the most efficeint you can buy today. An example would be to change a mains halogen GU10 35w lamp to a ECO friendly GU10 5w LED lamp. The same be done by changing the older GLS light bulb for a compact fluorescent lamp. Reduced energy bills with no loss of light output helps the environment and reduce your energy bills. 

IP Rating


All the luminaires on our web site have been specifically designed fit for purpose and assigned a relevant IP rating which denotes the amount of protection that is required from water and dust. More information on IP ratings can be found in the design ideas section on this web site.

Light levels ( LUX )

Light levels are measured in something called LUX. Put simply LUX is a measurement of light falling on a given surface area. For example an average LUX of 200 would be needed for an outdoor tennis court for recreational purposes and a side street  walkway would have an average of 5 LUX. To calculate lux levels you need a very good calculator or computer as there is a number of factors that need to be taken in to account.

Average levels of illuminance in Lux

Sunny June day 80000 Lux
Bad light stopped play at Lords 1000 Lux
A well lit office 500 Lux
Main road lighting 15 Lux
A residential side street 5 Lux
A clear moonlit night 0.2 Lux

Please ensure that a qualified NIC EIC electrician is consulted for the installation of all exterior lighting.

Features


Including a built-in electronic ballast for fast lamp start up and extended lamp life
Made in Germany
Powder coated body
Accessories for sign lighting
High output low energy lamps
IP65



maximum cable diameter: 7 - 12 mm
Bulb maximum diameter 6,6 cm, maximum length 17,3 cm

Item Specifications

colour: black
Lamp base: E27
Lamp description: energy-saving bulb E27 max. 24 Watt
Weight: 2.500 kg
Voltage: 230 Volt
Max wattage: 24 Watt
IP rating: IP 65
Materials: aluminium
Suggested lamp: 508770
Suggested accessories: 227770, 227774
Width: 22 cm
Height: 30 cm
Depth: 16 cm
Degree of tilt: 90