The Tiesto is a modern styled outdoor range constructed from die-cast aluminium for better heat dissipation. Fitted with
the latest COB technology, this exterior fitting provides a high light output whilst also maintaining low energy consumption.
- Textured black paint & opal pc
- Constructed from die cast aluminium alloy & polycarbonate
- Complete with LED driver
- 10W LED module (COB) Natural White (Included)
- K: 5000 Lm: 600 Lm/W: 60
- H: 400mm W: 180mm D: 100mm
- Class 1
- 5 Years Warranty
- Weight: 2.072 Kg
Bollard types and spacing
Bollard lights are available in a massive choice of styles, finish and lamp options. You need to think about how the light
will be used for example a small garden pathway, the main driveway, to illuminate steps etc. If you are within 20 km
of the coast you should think about using the wooden bollards or marine grade 316 stainless steel. Some bollards have built
in LED lamps and they generally offer lower levels of light ( lumen's ) than say a compact fluorescent. Also if the
lamp is an integral part of the bollard then it can not be replaced if it fails in future so you will have to purchase a
complete new bollard. There are bollards that use GU10 lamps and in this case can be changed for a ECO friendly GU10 LED
lamp. The spacing of the bollards will depend on the lamp output, louvre design, height etc but a general rule of thumb would
be no less than 3 mtrs and no more than 12 mtrs apart. The shorter distance would be for garden pathways and the longer distance
is for long driveways.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how
it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our
design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application
and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only
as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100%
water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin
mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing
ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible
use ground surface spike lights rather than a buried light. Mains 240v cable will have less joint than a low voltage
installation but care must be taken with the cable runs.
All exterior lights must be installed by a certified NIC EIC electrical contractor and all cable joints must be 100% watertight.
There are a selection of waterproof jointing kits and boxes available on this web site.
Care should be taken for the environment and local wildlife to maintain the ecological balance. Insects, bats, wildlife can
all be effected by light pollution. The warmer colour spectrum of ( 2,700 Kelvins ) does not interfere with
insects and general wildlife as much as the blue colour spectrum of light around 6,000 kelvins which can disrupt their normal
night time activity. This also applies to bats where a anti glare light fittings works better as well as reducing the overall
light pollution in the area. You must also be mindful of your neighbors and the effect your lighting can have on them and
shining a 500w tungsten halogen flood light in to their windows at night will cause them distress. Try to keep the light
in a downward position and local to the items you want to illuminate and even if you want to illuminate tall trees it can
be done in a sympathetic way by placing a ground buried or surface spike flood light directly under the trees to illuminate
the canopy. Some light fittings also have a anti glare shield fitted to reduce light pollution.