The Decimina 12 volt brass recessed deck light houses a replaceable 12v MR11 lamp; a smaller version of a standard MR16. A
strong 20mm brass rim with a rustic bronze finish secures the 30m diameter glass lens, with 3 screws. This finish really
blends in with natural surroundings and adds a touch of class to garden areas, traditional or contemporary. Once the 60mm
diameter mounting hole has been drilled, the small brass decking light simply slots into place. As well as decking, this
versatile light can also be used as a step light, in-ground light or wall light as it can be sunk into virtually any surface.
Approximately 5m of rubber cable comes with this deck light preventing unnecessary cable joins throughout the garden.
Not for use in areas prone to waterlogging or flooding
Solid Brass / ABS Thermoplastic
Rustic Bronze Finish (Antique)
Lamp Required / Max. Wattage MR11 LED / Halogen (Max. 35W) IP Rating IP67 (suitable for outdoor use) Lens Glass
Dimensions (approx.) (Diam.) 66mm x (Length) 98mm Installation Hole = 60mm Cable Included
2 Core 0.75mm² H05RN-F Rubber Cable (approx. 5m)
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Care must be taken with the cable runs and not to install transformers more than 30 metres away from the furthest fitting to avoid any voltage drop. Cabling should be 2 core Rubber HO5RN-F or HO7RN-F and not PVC. PVC leads to capillary action over time especially with UV degradation. Always check the correct type of transformer you need for your fittings. We recommend wiring in parallel with Toroidal AC and LED DC drivers. But when using Milliamp mA LED drivers, they should always be wired in series. Plug and Play kits are simply a case of daisy chaining the fittings via plug and play junction boxes, connectors and extension cables using a 2-pin plug arrangement.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.
|IP rating:||IP 67|
|Dimensions:||(Diam.) 66mm x (Length) 98mm Installation Hole = 60mm|
|Material Finish:||Rustic Bronze Finish (Antique)|
|cabling:||2 Core 0.75mm² H05RN-F Rubber Cable (5.0m)|
|lens:||Clear Lens, Frosted Lens|