The Stelled LED Marine Grade bollard light is available with a Professional ‘In-Ground’ Root Mount System.The Professional ‘In-Ground’ Root Mount System gives extra security and stability. Importantly, the tubular bodies of Root mount bollards are different to a standard types. Extended tubes allow at least 400mm to be concreted in-ground, without losing any height above ground. A strong mounting bar inside the tubular body also acts as an anchor when set into concrete.
The Stelled is a 3mm thick marine grade stainless steel bollard, suitable for commercial use.These robust bollards are ideal for large pathways, commercial seating areas and driveways. Stelled bollards are equally ideal as amenity lights for larger public areas, car parks, lakes, golf courses etc. These locations often require a high level of light. The innovative design of the head also allows space for a large 20W LED corn bulb. The 20w Corn Bulbs have an incredibly high lumen output (brightness).
A clear, UV stop polycarbonate diffuser surrounds the majority of the head (spares available). Silver aluminium internal louvres add character to the bollard and also act as anti-glare shields / protecting the LED bulb. All external screws are stainless steel Allen (socket) type to ensure a completely rustproof and non-corrosive product.
The distance between bollards varies depending on the bulb’s light output. Also the type of area and how much light you require. Below are some guidelines to determine how many bollards may be required for your project based on our recommended bulbs providing a constant light between each fitting.
The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700
kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.
|colour:||stainless steel 316|
|Voltage:||220 - 240v|
|Max wattage:||60 w|
|IP rating:||IP 65|
|Materials:||Marine Grade Stainless Steel (316) / Polycarbonate|
|Dimensions:||0.8m (+0.4m below ground), 1.0m (+0.4m below ground)|
|Sensor:||Photocell dusk to dawn|
|Material Finish:||316 Stainless Steel|
|lamp life:||30,000 hrs|
|colour temperature:||3000k Warm White, 6500k Cool White|
|mounting:||In-Ground Tubular Root Mount System|