Dolix Out, Outdoor, down light, MR16 Low Voltage, Silver grey, IP65
( REQUIRES TRANSFORMER )
The Dolix Out range is available in low voltage MR16 or mains voltage GU10 and a number
of colour options. MR16 Low voltage lamps are brighter than Mains GU10 lamps and have a wider lamp beam angle choice.
Can be used in soffits, porches, exterior ceiling voids.
When lighting is fixed into the soffit boards great lighting effects can be created
that wash the walls with light. Narrow beam lamps and coloured lamps can also be
used to make more of a decorative effect if desired.
Some soffit recessed lighting can be re-lamped from above and below to make maintenance
easier. Wiring regulations would suggest that a ingress protection of IP23 would
be sufficient in this location but using a fitting with a higher IP figure can only
ensure extra protection in exposed locations.
Where depth is available they can also be used in an entrance porch linked to a
motion detection PIR so they come on only when required. #
Energy efficient lamps
The use of energy efficient LED lamps are long lasting and therefore ideal
for areas where access is a problem and regular lamp changes would not be desirable. A typical saving of 88% is achievable.
Low voltage facts
A mains 240v supply comes in to a transformer which then steps the load down to
a safe 12v supply, this is particularly useful in gardens where there is a danger
of a fork or spade penetrating a cable.You will need to use a transformer which matches
the lamp voltage. For example if you had 6 fittings each with a MR16 35w lamp that
would be 6 x 35w = 210 watts so you would need a transformer that was about 250 va
as you need some spare capacity on the transformer for it to function correctly.
Standard MR16 low voltage lamps can use either an electronic or standard toroidal
type transformer but if you decide to use LED lamps then they work best on the toroidal
type transformer. Most of the transformers on our site are for outdoor use and have
a good IP rating.
Example of transformer loadings
We recommend you use the heat shrink kits for cable jointing or waterproof enclosure
boxes filled with Magic gel compound to keep the joints 100% water tight. These can
be found in the installation item section.
Please try and make all terminations above ground where there is less chance of
water ingress. All installations should be done by a NIC EIC electrical contractor
to ensure a safe and 100% water tight installation. Waterproof joint kits and boxes
are available from our web site.
Ceiling thickness max 15mm
Depth 130 mm
Cut out 70mm