01689 606342

Wallyx, fixed wall wash down light, silver, mains 240v GU10 lamp


Fashionably styled grey powder coated finished down only wall light for exterior use. Good wall wash effect and pathway light and very low glare.
Comes in a range of 3 colours. Easy to clean design and stylish body shape make this the perfect exterior wall mounted light fitting. Would also look good mounted to fence posts to illuminate a patio area, pathway or flower border.
The wallyx has nice angled lines which stands out from standard boxed styled or tubular wall lights. 4 retaining screws at the base make for simple lamp changes and the fitting is designed to minimise upward light pollution.

Comes in a range of 3 colours, Grey code 227194, Bronze code 227198 and Anthracite Code  227195. 


Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. 

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this website.                           


Item Specifications

colour: anthracite, bronze, Grey
Weight: 0.72kg
Voltage: 220 - 240v
Max wattage: 50 Watt
IP rating: IP 44
Materials: aluminium
Width: 10 cm
Height: 15.3 cm
Depth: 11.7 cm
Material Finish: Aluminium
Bulb Type: GU10
Warranty: 2 Years