01689 606342

Canon Up/Down 240v - Polished Stainless Steel IP44 2 x GU10 Security Wall Light With PIR Sensor


The Canon polished stainless steel up/down security wall light is a twin mains lamp fitting with a built in PIR sensor. One of our modern and high selling exterior security wall lights and one which compliments the outside of your home.

The mains 240v fitting has a clear glass lens and you can use 2 x GU10 LED bulbs up to a maximum wattage of 35w.

The PIR sensor sits at the base of the wall mount and has a detection angle of 110 degrees.   The timer can be set from as little as 5 seconds to a maximum of 5 minutes.

The sensor will be activated once it is dark and will switch the light on when it detects someone within it's range.

Comes in choice of twin wall fitting code EL-40062 or single wall light code EL-40063

NOT SUITABLE FOR COASTAL ENVIRONMENTS


  • Complete with built in PIR
  • 110° detection angle, 8m maximum range with a 5 sec - 5 min timer function
  • Polished stainless steel & clear glass
  • Constructed from stainless steel (201) & glass
  • IP44
  • Proj: 105mm H: 210mm W: 70mm
  • Class 1
  • 2 Years Warranty
  • Weight: 0.9 Kg

Lamp colour ( Kelvins )
 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. 


   

Installation - See attached downloads


   

This product is only suitable for connection to a 240V~50Hz supply. It is recommended that this light is installed by a qualified electrician in accordance with current IEE Wiring Regulations and local Building Regulations. The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp miniature circuit breaker). This light has an IP44 (splash proof) rating suitable for use outdoors. For optimum detection range a mounting height of 1.8M to 2.5M metres is recommended. Do not mount where the PIR can be activated by heat sources such as central heating vents, animals, traffic etc. Run supply wire from a 5-amp electrical supply using double insulated 3-core cable of type H05RN-F 1.0mm2 (not supplied) to selected site, ensuring it is adequately protected through the full length of the cable run, it must come out of the mounting surface in line with the entry to the fitting. Except where installed in a conduit or duct , which provides equivalent protection against mechanical damage, a cable buried in the ground shall incorporate an earthed armour or metal sheath or both, suitable for use as a protective conductor, or be of insulated concentric construction. Buried cables shall be marked by cable covers or a suitable marking tape. Buried conduits and ducts shall be suitably identified. Buried cables, conduits and ducts shall be at a sufficient depth to avoid being damaged by any reasonably foreseeable disturbance of the ground. This product contains breakable parts – be careful during handling and maintenance to avoid breakage. The bulb, body and lid cover can become hot in use. Switch off and allow 10 minutes to cool before cleaning (using a dry cloth only – do not use liquid or abrasive cleaners). If any part of the bulb housing is broken or cracked then it must be replaced immediately to preserve the water ingress protection, please consult your retailer.           
                         

Item Specifications

colour: stainless steel
Voltage: 240V
IP rating: IP 44
Materials: stainless steel
Width: 70mm
Height: 210mm
Product Type: Twin Wall light, Single Wall Light
Sensor: PIR
Material Finish: Stainless Steel
Bulb Type: GU10
Projection: 105mm
Warranty: 2 Years