240v Spike spotlights need their own circuit from an existing or new fuse box. The box must be protected by a residual current device (RCD) and controlled with a double-pole isolating switch. As a general rule of thumb, the armoured cables need to be run underground- at least 450mm with weatherproof junction boxes. Use an electrician qualified under 'Part P' building regulations to install any mains electricity outdoors who will certify the work properly.
Comes in a choice of 12v and 240v and colour finishes, Black, Rustic Brown and Stainless Steel.
2 metres of 3 core cable fitted for connection into a weatherproof junction box.
Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of separate RCD protection for each circuit and a maximum of 12 fittings per RCD. Where a garden lighting installation of more than 12 spike mount or recessed lights per circuit is proposed, we suggest the installation of 12v units with transformers, which results in a significantly higher fault tolerance and reliability in the total installation.
The exterior dimensions are 111mm x 63mm not including 250mm spike.
Comes pre-wired with 2m of 3 core rubber cabling.
Maximum size of GU10 72mm length not including pins.
Beam distribution 15 degrees to 120 degrees.
The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees. When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match.
All exterior lighting products on our website have an IP rating which is explained further in our Technical Help/Products section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas.
|colour:||Black, Natural Copper, Rustic Brown, stainless steel 316|
|Voltage:||12v, 220 - 240v|
|IP rating:||IP 65|
|Materials:||stainless steel 316|
|Material Finish:||316 Stainless Steel|
|Ground spike dimensions:||Length: 250mm approx.|