01689 606342


Compact spike light, 316 stainless steel, mains 240v, GU10, IP65


The E4112N garden spike spotlight is an adjustable 240v LED uplight constructed from 'shiny' marine grade 316 stainless steel. 240v models utilise GU10 lamps negating the need for a transformer. LED ground spike spotlights fitted with a flush glass lens to prevent water accumulation, a longer body to shield the lamp from view leaving sufficient space for glare louvres, clip on lens and dichroic filters. Choose a 5w or 7w warm white LED lamp to uplight pergola columns.

 240v Spike spotlights need their own circuit from an existing or new fuse box. The box must be protected by a residual current device (RCD) and controlled with a double-pole isolating switch. As a general rule of thumb, the armoured cables need to be run underground- at least 450mm with weatherproof junction boxes. Use an electrician qualified under 'Part P' building regulations to install any mains electricity outdoors who will certify the work properly.

The exterior dimensions are 111mm x 63mm not including 250mm spike.

Comes pre-wired with 2m of 3 core rubber cabling. 

Beam distribution 15 degrees to 120 degrees.

Maximum length of LED bulb to use must not exceed 72mm including the pins.

Lamp colour ( Kelvins )
 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour                    temperature to match.      

Installation 


All exterior lighting products on our website have an IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas


Item Specifications

colour: Black, Natural Copper, Rustic Brown, stainless steel 316
Voltage: 12v, 220 - 240v
IP rating: IP 65
Material Finish: 316 Stainless Steel
Bulb Type: MR16
Warranty: 5 year