01689 606342

Cone, surface, outdoor pillar lamp, E27 lamp base, IP54 Anthracite


The cone surface can be used as a pathway marker light or placed on top of a pillar as a welcome light. Also suitable on a small wall either side of steps.
It uses E27 light bulbs with a maximum of 100w, however we recommend that you choose the energy efficient LED E27 light bulbs which only use a fraction of the watts and give good lumen brightness and colour temperatures.

The fitting is 24cm in height with overall diameter of 19cm and will throw light around it to provide low level pools of light on the ground and any adjacent structures such as walls. It is mains 230v and IP54 rated. It is constructed from Aluminium and Glass and comes in Anthracite.

Bollard types and spacing

Bollard lights are available in a variety of styles, finish and lamp options. You need to think about how the light will be used for example a small garden pathway, the main driveway or to illuminate steps etc.  If you are within 20 km of the coast you should think about using the Wooden, Copper, Iron, Brass or Marine Grade 316 Stainless Steel. Some bollards have built in LED modules which generally offer lower levels of light (lumens) than a standard LED GU10 lamp. Also, it is likely the LED module is a sealed unit and an integral part of the bollard which cannot be replaced if it fails meaning you will have to purchase a complete new bollard. There are bollards that use GU10 LED lamps and E27 base LED lamps. The spacing of bollards will depend on the type of bollard, louvre design, height and lamp output etc but a general rule of thumb would be no less than 3 meters and no more than 12 meters apart. The shorter distance would be for garden pathways and the longer distance for long driveways.

                                                                


                                 

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.



Item Specifications

colour: anthracite
Overall diameter: 19 cm
Weight: 2.550 kg
Voltage: 220 - 240v
IP rating: IP 54
Materials: aluminium
Height: 24 cm
Material Finish: Aluminium
Bulb Type: E27
watts: max 100w
Warranty: 2 Years