01689 606342

Dasar 70 -  GU10, ground recessed,

304 stainless steel cover, 30 degree tilt, IP67

The Dasar 70 -  GU10 is an aluminium body fitting with a 304 stainless steel top cover, designed for exterior ground use and is IP67.
It's used with a GU10 LED lamp so the fitting is safe to touch and ECO friendly. There is a black ground potting pot included with the fitting.This fitting can take a maximum load of 2 tons provided it is installed into concrete and can be used as a drive over light. There is also 30 degree of tilt angle available in this ground light. 90 degree horizontal rotation. 

The fitting is 13cm x 13cm square and 12cm depth. Installation depth 13.5cm. .

The cut out is 12.4cm x 12.4cm and to accomodate the black pot which can be used also as the template for the installation.

It is mains 230v and has a 90 degree rotation.

LED lamps will create a good deal of lumen brightness and have a long life, use minimal electricity and are cool to touch, making them safe around children.

Lamp colour ( Kelvins )


 The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match.  


Please check the specification for dimensions before purchasing.

It is important that adequate drainage is allowed for when installing this type of product especially in clay based soil beds.
A NIC EIC electrical contractor should be used to ensure a 100% water tight installation. There are resin kits and heat shrink kits available from us to help make the perfect waterproof joint.

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix or magic gel. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas.

Item Specifications

colour: stainless steel 304
Cut out: 12.4 x 12.4 cm
Installation depth: 13.5 cm
Weight: 1.150 kg
Voltage: 240V
IP rating: IP 67
Materials: stainless steel 304
Length: 13 cm
Width: 13 cm
Height: 12 cm
Degree of tilt: 30
Material Finish: Stainless Steel 304
Bulb Type: GU10
watts: Max 35w
rotation: 90 degree
Warranty: 2 Years