The GRAFIT wall light is part of a small family of light fittings with timeless design including two sizes of bollard lights which can be spiked in to soft ground. Codes 231225 and 231215.
Beautifully finished in Anthracite with opal lens which throws a soft light in a 60 degree direction and using E27 base LED lamps.
This very modern fitting has been popular with customers for several years and the shades are made from frosted plastic held in smoked grey glass effect.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light. Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.
|Max wattage:||11 w|
|IP rating:||IP 44|
|Material Finish:||Aluminium / Plastic|