01689 606342

Louvre bollard, 1m tall black, IP44, mains 240v, E27

The 1m high Surface mounted traditional style Black louvered bollard with toughened polycarbonate body for use in most applications including gardens, patios and courtyards. There are 2 sizes of the louvre bollard. This one at 1m and the smaller bollard 650mm tall. Due to the design of the louvre the fitting is very low glare and keeps light pollution to a minimum. The light is pushed down to the floor where it is needed most.  You can also use energy efficient E27 screw base LED lamp to further reduce maintenance and energy bills. 

Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, carefully note the position of each set of wires. • The product must be mounted onto a concrete base or paving slab. It should not be directly installed in the soil.
 • Position the supplied right angle J bolts as shown in the diagram in the download.  Use the base of the unit for alignment
 • Position the conduit or plastic trunking so that the cable comes up that the centre point of the bollard. Ensure that the cables do not snag.
 • Double check that the fixings line up with the holes in the base of the fitting before concreting into position, and allow to set. 


Bollard types and spacing


Bollard lights are available in a variety of styles, finish and lamp options. You need to think about how the light will be used for example a small garden pathway, the main driveway or to illuminate steps etc.  If you are within 20 km of the coast you should think about using the Wooden, Copper, Iron, Brass or Marine Grade 316 Stainless Steel. Some bollards have built in LED modules which generally offer lower levels of light (lumens) than a standard LED GU10 lamp. Also, it is likely the LED module is a sealed unit and an integral part of the bollard which cannot be replaced if it fails meaning you will have to purchase a complete new bollard. There are bollards that use GU10 LED lamps and E27 base LED lamps. The spacing of bollards will depend on the type of bollard, louvre design, height and lamp output etc but a general rule of thumb would be no less than 3 meters and no more than 12 meters apart. The shorter distance would be for garden pathways and the longer distance for long driveways.


Lamp colour ( Kelvins )


The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Item Specifications

Colour: Black
Voltage: 240v
Max wattage: 60w
IP Rating: IP44
Materials: Aluminium
Height: 1.0m, 650mm
Dimensions: 650mm height x 170mm diameter
Bulb Type: E27
diameter: 170mm
Warranty: 2 Years