01689 606342

Modula ground, 30 degree adjustable, up light, round, Textured brass, 12v, IP67

E8761N is a stylish 12v recessed up-light with a choice of 20-50w halogen lamp or low energy LED lamp. Modula is fitted with a flush lens as standard. The light is located by an O ring on the body into a sleeve tube. To facilitate removal of screws for future re-lamping or other maintenance, apply copper grease to the threads of all screws being fitted for retention of bezels, grills or other top plates or retaining rings. Copper grease resists degradation due to heat and protects against difficulty in removing screws, particularly where stainless steel screws are fitted with aluminium parts. It may also be used on screw threads of screw-off bezels or glare shields. Ensure surplus is cleaned off with a solvent to prevent staining in use.

Colour/Finish: Fine sandblasted cast brass finish looks good on decking, timber, sandstone and buff brick
IP Rating: IP67
Construction: Front bezel is attached to tubular aluminium body. 1m cable via rear entry cable gland
Input Voltage: 12v
Lamp Type: MR16 20w or 50w halogen lamp or MR16 L.E.D. lamps include white or warm white 3w or 5w; 50,000 life and low energy consumption make them a popular option
Installation: The plastic sleeve is built in during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an o-ring. Connect input cable to cable from transformer using T9962 cable joint or T9963 cable splice kit.

Installation 12v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Care must be taken with the cable runs and not to install transformers more than 30 metres away from the furthest fitting to avoid any voltage drop. Cabling should be 2 core Rubber HO5RN-F or HO7RN-F and not PVC. PVC leads to capillary action over time especially with UV degradation. Always check the correct type of transformer you need for your fittings. We recommend wiring in parallel with Toroidal AC and LED DC drivers. But when using Milliamp mA LED drivers, they should always be wired in series. Plug and Play kits are simply a case of daisy chaining the fittings via plug and play junction boxes, connectors and extension cables using a 2-pin plug arrangement. 

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Fittings using MR16 LED lamps and Toroidal or Constant Voltage drivers should be wired in Parallel


Item Specifications

colour: Brass
Voltage: 240V, 12v
IP rating: IP 67
Materials: Aluminium/Brass
Degree of tilt: 30
Material Finish: Aluminium
Bulb Type: MR16
shape: circular, Square bezel
Warranty: 2 Years