01689 606342

Moonray - 12v Hanging Light - Rustic Brown Finish - MR16 - IP23 - Open Cable - Available in Copper, Black and Brown

The Moonray code E7871 is a 12v decorative hanging downlight with a long decorative perforated barrel. It has an open base and can accommodate a clip-on MR16 accessory such as a frosted lens, glare louvre or colour filter. The fitting uses MR16 LED bulbs. The natural copper blends well with red brick and timber.

Also available in Black or Brown colour finishes.

The suspended hanging downlight can be strapped to a tree branch or suspended from a brass hook or bracket to illuminate a seating area or feature below. It has an open base and holes drilled in to the main body shaft to throw a twinkle light effect around the surrounding area. It can be hung over a seating area and a pool of light will illuminate the bench. Light is thrown down onto the floor or seating area below and a round circle of light is produced. The size of the circle is determined by the beam angle of the lamp you install. Can be used with a variety of MR16 LED lamps ideally in warm white. These lights also look good suspended just above a veranda  for a soft evening light or suspended from a wrought iron arm over a BBQ cooking area. 

Lamp colour ( Kelvins )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour                    temperature to match.      

Installation 12v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Care must be taken with the cable runs and not to install transformers more than 30 metres away from the furthest fitting to avoid any voltage drop. Cabling should be 2 core Rubber HO5RN-F or HO7RN-F and not PVC. PVC leads to capillary action over time especially with UV degradation. Always check the correct type of transformer you need for your fittings. We recommend wiring in parallel with Toroidal AC and LED DC drivers. But when using Milliamp mA LED drivers, they should always be wired in series. Plug and Play kits are simply a case of daisy chaining the fittings via plug and play junction boxes, connectors and extension cables using a 2-pin plug arrangement. 

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.                     




Item Specifications

colour: Black, Rustic Brown, Copper
Voltage: 12v
IP rating: IP 23
Materials: Rustic Brown
Material Finish: Rustic Brown powder-coated aluminium
Bulb Type: MR16
cabling: 2 Core 0.75mm² H05RN-F Rubber Cable (1.0m)
Warranty: 2 Years