01689 606342

Mon - Fri: 9am - 5:00pm

Cart | 0 item (£0.00)
Your Cart is Empty

01689 606342

Motion PIR 240v - Gloss White Polycarbonate E27 IP44 Security Wall Light With PIR Sensor


The Motion security PIR bulkhead is made from tough, vandal resistant polycarbonate and suitable for both commercial and domestic applications.
This vandal resistant security light is ideal for illuminating the balconies for apartment blocks.  It uses an E27 LED bulb.  Not supplied but we have a variety to choose from.
  • Complete with built in PIR
  • 110° detection angle, 10m maximum range with a 5 sec - 4 min timer function
  • Frosted & gloss white pc
  • Constructed from polycarbonate
  • 60W E27 GLS (bulb not included)
  • IP44
  • Proj: 112mm H: 276mm W: 113mm
  • Class 1
  • 2YR Warranty
  • Weight: 0.6 Kg
   

           


    Lamp colour ( Kelvins )
     

    The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. 


    Installation 

                       

    Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, carefully note the position of each set of wires.

    Remove the lampshade from the product using a screwdriver.
    Unscrew Screw A and remove the Transparent Plate
    Hold the product in position and mark the location of the fixing holes. Lamp holder must face upwards.

    Thread the cable through the rubber grommet in the back plate.
    Fix the wall back to the wall using the screws and plugs supplied. Ensure the wall is capable of holding the weight of the product. Take care to avoid damaging any concealed wiring and pipes. The correct fixings should be used for brick or cavity walls.
    Wire as detailed in the instructions attached in the download.

    Make sure you have correctly identified the wires.
    Checked the connections are tight. That no loose strands have been left out of the connection block.

    Once the bulb is fitted, reattach the transparent plate and lampshade.
    Replace fuse or circuit breaker and switch on. Your light is now ready for use.


    Item Specifications

    Colour: White, Black
    Weight: 0.6kg
    Voltage: 240v
    IP Rating: IP44
    Materials: Polycarbonate
    Width: 113mm
    Height: 276mm
    Sensor: PIR
    Sensor_Description: 110 degree detection angle, 10m maximum range with a 5 sec - 4 min timer function
    Bulb Type: E27
    Projection: 112mm
    additional information: complete with Built in PIR
    Warranty: 2 Years
    Watts: Max 60W