The Mystic Wall Light is a Globe shaped wall lantern with a bright white globe / lens, and a matt black frame, which surrounds the lower half of the Globe, and a particularly striking mounting bracket which has swirl detail attached to the underside of the 215mm protruding arm.
An ornate outdoor light with swirl detail adds further character to the outdoor wall light. This also acts as a base and surround for the Globe to sit in. The Globe diffuser is a 2 part, extremely robust and vandal resistant polycarbonate. Removing the top half allows easy replacement of the standard ES lamp, and is secured by three stainless steel screws.
The frame is made from rust proof Aluminium which is chromate treated prior to painting. This prevents the Aluminium oxidising and the paint flaking off, as it may do with fittings which have not been treated.
This fitting also comes with an option for a Dusk to Dawn Photocell code number LLMSTW-WL-PC, as a PIR sensor light code LLMSTW-WL-PIR and as a Pedestal light code LLMSTW-PD.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.
|IP rating:||IP 44|
|Sensor:||PIR, Photocell dusk to dawn, None|
|Material Finish:||Aluminium / Polycarbonate|