The high quality powder coated exterior body provides added durability to this IP65 outdoor garden spike light.
Ground spike lights are the most popular and flexible light fittings we sell and can be used for numerous areas to illuminate small trees and shrubs as well as garden ornaments and water features. The spike can also be removed and the attached bracket can be used to wall mount the spot light which can be directed at an eating area or BBQ. You could fix them on the underside of the top of a pergola and send a pencil beam of light down to the floor to illuminate the pathway below or back light a bench area, the possibilities are endless and they are a very easy and cost effective solution to illuminate an outdoor space. Cable supplied should be installed above ground or put into waterproof tubing. If received with 2 pin plug that can be removed or we can supply a 3 pin plug.
Available in Stainless steel code 229740, Rust code 1001964, Black code 227410 and Green code 1001965.
The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees. When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match.
All exterior lighting products on our website have an IP rating which is explained further in our Technical Help/Products section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable joints. All joints must be made 100% water tight and this can be done using IP68 inline connectors, waterproof junction boxes which are then filled with a resin or gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas.
|colour:||Green, Black, Grey, stainless steel 316, Rust|
|Overall diameter:||9.5 cm|
|Voltage:||230v - 50Hz|
|Max wattage:||11 w|
|IP rating:||IP 65|
|Degree of tilt:||180|
|Ground spike dimensions:||17.5cm|