01689 606342

Navigator Maxor  - 316 stainless steel - 12v - Round - Warm White, 2700 kelvin's, LED 1w


Navigator Maxor is the largest recessed LED light in a family of three sizes used to outline a deck or paving, light steps or provide cool up-lighting.

The E3311WW is a low energy, warm white LED deck and recessed light which consumes a small amount of power and stays cool to the touch. The warm white  LED produces a wide 80° beam diffused by the 28mm diameter frosted lens to provide soft lighting compatible with the colour of halogen garden lighting. Navigator Maxors are used either to mark out the shape of a deck, patio or terrace, to outline paths and to light steps. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space LED recessed garden lights at about 1 - 1.5m apart. 

12v 1.5w: NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator LED lights. If powering from a 12v ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating.

Please note that the B9403N DC 15w transformer will only accommodate up to 8 of these fittings.

Constructed from 316 grade stainless steel, the IP65 rated Navigator Maxor externally measures 60mm diameter by 54mm in length. Illumination is provided from an integral single 1w 101 lumen warm white (2700K) LED, diffused by a 28mm diameter frosted lens. Comes supplied with 1m H05RN two core cable and plastic sleeve. Plastic sleeve externally measures 48mm diameter by 70mm in length.


Installation 12v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Care must be taken with the cable runs and not to install transformers more than 30 metres away from the furthest fitting to avoid any voltage drop. Cabling should be 2 core Rubber HO5RN-F or HO7RN-F and not PVC. PVC leads to capillary action over time especially with UV degradation. Always check the correct type of transformer you need for your fittings. We recommend wiring in parallel with Toroidal AC and LED DC drivers. But when using Milliamp mA LED drivers, they should always be wired in series. Plug and Play kits are simply a case of daisy chaining the fittings via plug and play junction boxes, connectors and extension cables using a 2-pin plug arrangement. 

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.


Step lighting example

                    

  



MUST BE WIRED IN PARALLEL  


     


          

Item Specifications

colour: stainless steel, Natural Copper
Voltage: 12V dc
IP rating: IP 65
Lumens: 101 lm
Material Finish: Natural Copper
Bulb Type: integral LED
watts: 1w
colour temperature: 4000k cool white, 2700 warm white, 4000 Kelvin, 2700 Kelvin
Warranty: 2 Years