01689 606342

Navigator Maxor  - copper - 12v - Round - Warm White, 3000 kelvin's, LED 1w

E3321WW is a low energy, warm white l.e.d. deck and recessed light which consumes a small amount of power and stays cool to the touch. The warm white led produces a wide 800 beam diffused by the 28mm diameter frosted lens to provide soft lighting compatible with the colour of halogen garden lighting. Navigator Maxor are used either to mark out the shape of a deck, patio or terrace, to outline paths and to light steps. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space led recessed garden lights at about 1 - 1.5m apart.


All recessed luminaries must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joint must be 100% watertight and there a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections and transformer be kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal.

Step lighting example




copper finish looks good on decking, timber, sandstone and buff brick

IP rating

IP67 see design ideas section for more details


Long life high-output l.e.d resin-encapsulated behind a frosted glass lens in a stainless steel case. The case has a spring mount which locates the light in a sleeve used to prepare positions in concrete, paving or walls. They can be recessed without the sleeve in decking sleeper walls and other materials using a 44mm hole saw. Diameter 60mm (sleeve 48mm; 44mm cut-out without sleeve) recess depth 75mm.

Input voltage

12v  2.2W ( TOTAL LOADING ): NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable with a heat-shrink crimped-connector weatherproof Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable) or T9963 Cable Splice Kit (for connecting into a run of cable). NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator led lights. If powering from a 12v 20va or 50va ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating.

Transformer loading example




Lamp type

1w warm white led. 2.2w total load

MUST BE WIRED IN PARALLEL please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit; for splicing into a run of cable use T9963 cable splice kit.



                                                    The top section of this l.e.d. light can be unscrewed to allow the insertion of theatrical coloured gels to enable

Item Specifications

colour: stainless steel, Natural Copper
Lumens: 100 lumens
colour temperature: 3000 Kelvin, 4000 Kelvin, 2700 Kelvin