01689 606342

Navigator Minor led light - 316 stainless steel - 12v - Round - cool white 4,000 kelvin, led 0.3w

The E3111W-N is a white LED deck and recessed light which consumes a tiny amount of power and stays cool to the touch. The 0.3w LED produces a wide 80 degree beam angle  diffused by the 16mm diameter frosted lens. They are used either to mark out the shape of a deck, patio or terrace, to outline paths and to provide marker lighting in step risers. To outline a deck or patio space with a distinctive shape, start at the corners of the decking or paving and space LED recessed garden lights at about 60cm - 1m apart in step risers, space them about 60cm apart along the centre line of the riser


All recessed luminaries must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joints must be 100% watertight and there are a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections and transformers are kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.
Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal.

Step lighting example




Each light contains long life high-output LED resin-encapsulated behind a frosted glass lens in a stainless steel case. The case has a spring mount which locates the light in a sleeve used to prepare positions in concrete, paving or walls. They can be recessed without the sleeve in decking, sleeper walls and other materials using a 28mm wood drill bit. Diameter 40mm (sleeve 32mm; 28mm cut-out without sleeve) recess depth 75mm. The top section can be unscrewed to allow insertion of theatrical coloured gels.

Input voltage

12v 0.5w:( TOTAL LOADING ) NAVIGATORS should be connected to 1.5mm or 2.5mm ground burial low voltage cable with a heat-shrink crimped-connector weatherproof Joint Kit - T9962 Cable Joint Kit (for connecting to the end of a cable) or T9963 Cable Splice Kit (for connecting into a run of cable). NAVIGATORS should be powered by 12v dc power supply. Do not use an electronic transformer to power Navigator led lights. If powering from a 12v 20va or 50va ac wire-wound transformer, ensure transformer is loaded to at least 75% of nominal rating.

Lamp type

1 X 0.3w  white LED

Lamp colour ( Kelvins )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees.  When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match. Coloured filters are good to use with the LED bulbs too especially in winter using green filters give the appearance the trees are still in leaf.



MUST BE WIRED IN PARALLEL please ensure the transformer has the correct loading.
Navigator lights can be arranged in custom layouts using cable joint kits and 1.5mm cable, which is more flexible than kit-type products. Connect to the end of a low voltage cable using T9962 cable joint kit, for splicing into a run of cable use T9963


Item Specifications

colour: stainless steel
IP rating: IP 67
Lumens: 21.5 Lumens