01689 606342

 Olympus 70 - 240v Metal Halide 316 Stainless Steel Bezel & Aluminium Body IP67 Recessed Light - Uses 70w CDMT Lamps                      



Recessed adjustable up lights combine a cool top lens, long lamp life and energy efficiency for up lighting trees from lawns or paving. Olympus provides a powerful 36 degree up lighting beam, using a single-ended metal halide lamp, while maintaining a typical top lens temperature of under 70 degrees Celsius. So Olympus can be used even in walkover areas to up light trees with an open canopy and branch structure from directly below. The lamp and reflector assembly is mounted on an adjustable cradle so the beam can be tilted up to 20 degrees from vertical to achieve the desired effect. The dark grey non-reflective interior means less light refraction through the lens to give away its position in the landscape. Olympus has an upper compartment with a separate top lens insulated by an inner second lens from heat generated in the lower compartment which houses the lamp and control gear. Olympus has a 316 stainless steel lens rim, a cast aluminium body and a polymer sleeve for recessing into the ground. A sandblasted brass top ring is available for discrete installation in paving, especially in heritage projects where stainless steel may look too modern, green and black tops are also available. An 8mm thick black honeycomb glare louvre (E9500L) is also available as an accessory: this fits inside the top compartment over the lower lens to limit visibility of the light source in traffic or pedestrian areas. To facilitate removal of screws for future re-lamping or other maintenance, apply copper grease to the threads of all screws being fitted for retention of bezels, grills or other top plates or retaining rings. Copper grease resists degradation due to heat and protects against difficulty in removing screws, particularly where stainless steel screws are fitted with aluminium parts. It may also be used on screw threads of screw-off bezels or glare shields. Ensure surplus is cleaned off with a solvent to prevent staining in use.



Installation advice

This direct burial in the ground fitting is pre-wired with rubber cable and 20mm IP68 gland for connection to mains supply via a separate underground joint kit (order T9969 separately). You will need to provide 300mm depth of shingle drainage below the uplight: do not use in waterlogged ground.

All recessed luminaries must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joints must be 100% watertight and there are a number or waterproof junction boxes on our web site to choose from. 

A 70w single-ended ceramic type CDMT70 3000K metal halide lamp is recommended for purple/red/yellow/green foliage trees and combines long lamp life and colour stability. CDMT70 4000k lamp gives a cooler lighting effect suitable for trees with blue/grey foliage such as some pines & cedars. Order lamps separately.



Item Specifications

Beam Angle: 36 degree
colour: Green, stainless steel, Black, Brass
Voltage: 220 - 240v
IP rating: IP 67
Materials: aluminium / stainless steel 316
Degree of tilt: 20 degree
Material Finish: Aluminium / Stainless Steel 316
Bulb Type: G12
Warranty: 2 Years