01689 606342



                             OUT 65 - Fixed Square White 240v IP65 11w 3000k 640 Lumens 38 Degree Beam Angle Recessed Soffit Light


The Out 65 round/square range of LED mains 220 - 240v fittings are the latest in LED outdoor recessed downlights and perfect for soffit areas, porches and exterior ceiling voids which have a material thickness of up to 20mm. When lighting is fixed into the soffit boards you will get great lighting effects as the integral warm white 3000k LED module will give out 640 Lumen with a 38 degree beam angle and the total consumption will be 11w.

The fitting is IP65 which translated for water ingress is protection against jetting water.

The fitting has a built in 500mA constant current driver and the COB (Chip on board) LED module should last up to 40,000 hours.

It comes in White code number 114471.There is a round bezel version too. Codes 114460 Black and 114461 white .

Wiring regulations would suggest that a ingress protection of IP23 would be sufficient in this location but using a fitting with a higher IP figure can only ensure extra protection in exposed locations.

Where depth is available they can also be used in an entrance porch linked to a motion detection PIR so they come on only when required. 

 

Lamp colour ( Kelvins )

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site

                   

Item Specifications

Beam Angle: 38 degree
colour: white, Black
LED: LED Driver included
Cut out: 7cm
Overall diameter: 8.5cm
Voltage: 240V
IP rating: IP 65
Materials: aluminium / glass
Depth: 4.7cm
Dimmable: yes
Lumens: 510 lumens
Material Finish: Aluminium
Bulb Type: integral LED
diameter: 8.5cm
watts: 11w
colour temperature: 3000k Warm White
additional information: Ceiling material thickness 20mm
Bezel: Round Bezel, Square Bezel
Warranty: 2 Years