01689 606342


Pillar round marine grade IP65 50W recessed - marine grade brushed stainless steel 230v  Cable entry IP67


This fitting is manufactured from Marine Grade stainless steel making it the ideal choice for marine or seaside locations. Built to last and suitable for walkover applications. Also available in a square shape. Suitable for use with energy compatible lamps. The low profile design is discreet and attractive.

Dimmable with LED dimmable bulbs and compatible dimmer systems. Complete with fixing accessories.

5mm projection x 105mm diameter.  Class 1 . Check the Downloads tab above for full installation instructions and measurements.

This product is dual IP rated. The visible part is rated at IP65, and the cable entry is rated at IP67. They require drainage underneath them especially with clay based soil, but should cope with short periods of temporary immersion.

Lamp colour ( Kelvins )
 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. 

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of separate RCD protection for each circuit and a maximum of 12 fittings per RCD. Always put outdoor lighting on it's own RCD. Where a garden lighting installation of more than 12 spike mount or recessed lights per circuit is proposed, we suggest the installation of 12v units with transformers, which results in a significantly higher fault tolerance and reliability in the total installation.

    

Item Specifications

colour: stainless steel 316
Voltage: 220 - 240v
Max wattage: 50 Watt
IP rating: IP 65
Materials: Constructed from marine grade stainless steel (316l) & polycarbonate
Dimensions: 5mm projection x 105mm square
Bulb Type: GU10
watts: Max 50w
shape: circular, Square