01689 606342

                             

Severus landscape indirect IP65 2W warm white wall - Grey ABS Plastic - 220 - 240v


The Severus is a range of surface mounted LED guide lights which are quick and easy to fit. Manufactured from polycarbonate, they are not suitable for coastal locations. Available in a choice of direct (downward) and indirect (upward) light, design and finish.

NOT SUITABLE FOR A MARINE ENVIRONMENT AND BY THE COAST


  • The clever design means that you can now fit guide lights when you are not able to cut holes in your wall. The slim profile and integrated driver allows us to keep the projection from the wall to a minimum and the IP rating is ensured by the gasket and the diffuser when it is fitted into place. The outer cover simply clips into place to complete the installation
  • Complete with fixing accessories
  • Grey abs plastic & clear pc
  • Constructed from abs plastic & polycarbonate
  • Complete with integrated control gear
  • 2W LED module (SMD 3014) Warm White (Included)
  • K: 3000 Lm: 65 Lm/W: 33
  • IP65
  • Proj: 27mm H: 80mm W: 230mm
  • Class 2
  • 2 Years Warranty
  • Weight: 0.2kg

A guide to lighting steps

                                                                             

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Using a single RCD for large numbers of 240v fittings is not recommended due to the risk of nuisance tripping. We advise the use of separate RCD protection for each circuit and a maximum of 12 fittings per RCD. Where a garden lighting installation of more than 12 spike mount or recessed lights per circuit is proposed, we suggest the installation of 12v units with transformers, which results in a significantly higher fault tolerance and reliability in the total installation.                                              

            

Item Specifications

colour: Black, Grey
Weight: 0.322 Kg
Voltage: 220 - 240v
IP rating: IP 65
Lumens: 65 lm
Material Finish: Constructed from polycarbonate & abs plastic
Bulb Type: integral LED
watts: 2w
colour temperature: 3000k Warm White
additional information: Complete with integrated control gear
Warranty: 2 Years