01689 606342

Slots 65 - LED Bollard in Rust finish 230v



The Slots 65 is an attractive yet commercial style LED bollard which comes in two heights and two colour finishes. 

It comes with a 3000k colour temperature warm white COB (Chip on board) LED with 200 lumen output.  The total wattage consumption is 6.3w.

It is made from Aluminium and the two colour finishes are Anthracite and Rust.

The two heights are 465mm and 665mm.

It comes complete with the LED COB light module and also a concrete anchor set, But you can add accessories such as the Hanger bolt set and IP68 3-pole connection box for watertight connection for the cabling installation.

The LED module is integrated in the head piece of the bollard/path light and radiates downwards so that any glare is effectively reduced.

Bollard types and spacing

Bollard lights are available in a variety of styles, finish and lamp options. You need to think about how the light will be used for example a small garden pathway, the main driveway or to illuminate steps etc.  If you are within 20 km of the coast you should think about using the Wooden, Copper, Iron, Brass or Marine Grade 316 Stainless Steel. Some bollards have built in LED modules which generally offer lower levels of light (lumens) than a standard LED GU10 lamp. Also, it is likely the LED module is a sealed unit and an integral part of the bollard which cannot be replaced if it fails meaning you will have to purchase a complete new bollard. There are bollards that use GU10 LED lamps and E27 base LED lamps. The spacing of bollards will depend on the type of bollard, louvre design, height and lamp output etc but a general rule of thumb would be no less than 3 meters and no more than 12 meters apart. The shorter distance would be for garden pathways and the longer distance for long driveways.

                                                                 

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.                                            

           


Item Specifications

colour: anthracite, Rust
Voltage: 220 - 240v
IP rating: IP 44
Height: 465mm, 665mm
Lumens: 200 lm
Material Finish: Aluminium
Bulb Type: integral LED
diameter: 90mm
watts: 6.3w
colour temperature: 3000k Warm White
Warranty: 2 Years