01689 606342

Smoothie recessed light - Stainless steel - 240v GU10

E8012 is a stylish 240v recessed stainless steel light for illuminating steps or patios with a choice of 20-35w halogen lamp, low energy led module or GU10 compact fluorescent lamp. Smoothie is fitted with a flush frosted lens as standard to diffuse the lighting. The light is located by an “O” ring on the body into a sleeve tube so that no external screw fixings are visible. Remember that recessed step lights are in effect recessed spotlights - avoid using them facing viewpoints to reduce glare.The edge or the fitting has a slight bevel edge to it which adds to the aesthetical effect of the luminaire and makes it safe to walk over. The front bezel unscrews for easy lamp replacement and cleaning.Can be used with a GU10 LED lamp to reduce heat and electricity bills.

Remember that recessed step lights are in effect recessed spotlights - avoid using them facing viewpoints.

Lighting steps example


Colour / Finish

316 grade stainless steel

IP rating

IP66 see more details on IP ratings in our design ideas page


Front bezel is attached to tubular aluminium body which unscrews into 2 halves without tools for easy lamp changing. 1m cable via rear entry cable

Input voltage


Lamp options

LED GU10 bulbs 3w and above.  Lumen output from 250 lumens.  Colour temperatures 2700k - 6500k - warm white to cool white.



The plastic sleeve is built into the wall during construction or retrofitted into a hole cut with a coring bit: the light pushes into the tube, where it is held firmly in place by an o-ring, leaving a front plate with no visible fixing screws. Suitable drainage should be provided below each fitting to prevent water logging. Smoothies should not be installed in ground subject to water logging, an IP68 light should be considered.

All recessed luminaires must have adequate drainage beneath each fitting to allow water to disperse, especially in clay based soil beds. All cable joint must be 100% watertight and there a number or waterproof transformer boxes and heat shrink cable joint kits on our web site to choose from. We would advise that all connections be kept above ground where possible as the weakest link in any exterior garden electrical installation is joining cables together.

Please ensure that your electrician is NIC EIC certified and has done exterior lighting installations before. Also ensure that all rubber gaskets are clean and dry before screwing down the front glass and bezel for a water tight seal. We would suggest you use a copper grease on the fixing screws to reduce corrosion and make life easier when you need to remove the bezel.

Item Specifications

colour: stainless steel 316
Voltage: 12v, 220 - 240v
IP rating: IP 65
Materials: stainless steel 316 bezel and aluminium body
Dimensions: 110mm x 63mm body
Material Finish: Stainless Steel 316 Bezel And Aluminium Body
additional information: Sleeve 120mm x 67.5mm Bezel 88mm diameter 44mm polycarbonate centre diameter